ASTM D Standard Test Method for Ball-Pan Hardness of Activated Carbon. Standard Test Method for Ball-Pan Hardness of Activated Carbon. Status: Withdrawn · Replaced by: ASTM D Buy this standard. Price: SEK. PDF. D()活性碳的球盘硬度的试验方法 – Designation: D Referenced Documents ASTM Standards: B 19 Speci?cation for.

Author: Juzahn Gagore
Country: Jordan
Language: English (Spanish)
Genre: Politics
Published (Last): 4 June 2004
Pages: 233
PDF File Size: 1.72 Mb
ePub File Size: 20.68 Mb
ISBN: 910-4-34178-831-5
Downloads: 16728
Price: Free* [*Free Regsitration Required]
Uploader: Vurg

ASTM D – 16 Standard Test Method for Ball-Pan Hardness of Activated Carbon

Sieves shall be calibrated at reasonable intervals in accordance with the procedure described in Speci? Weigh to the nearest 0. Satm the fractions above the larger and below the smaller nominal particle size. The extra sieves, in this case, serve only to form a stack which? Current edition approved June 29, Pour the screened and weighed sample into the hardness pan and add the steel balls.

Precision and Bias astn Obtain at least mL of material within the nominal mesh size range. Humidity effects during a given test will largely cancel out if no change in humidity occurs between 9. One supplier tested 31 samples of a single grade of carbon and obtained an average hardness of It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters.

The value of H2 gives the upper limit of hardness, if we ignore the effects of humidity.

Use additional material obtained as in 9. Shake with the hammer operating for 10 min 6 10 s.

Place the hardness test sieve on top of the receiving pan. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.

Adjust the bottom stops to give a clearance of approximately 1. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. At the end of this period, the amount of particle size degradation is determined by measuring the quantity of carbon, by atm, which is retained on a sieve whose openings are closest to one half the openings of the sieve that de? Fit the cover plate with a cork stopper which extends from 3.

Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm. A number in parentheses indicates the year of last reapproval. Tyler Model SB, available from W.


Standard Test Method for Ball-Pan Hardness of Activated Carbon – CERN Document Server

Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. None of these has proved completely satisfactory for all applications, and all have been questioned by ASTM Committee D on Activated Carbon as tests for establishing degradation resistance.

This standard is subject to revision at any time by the responsible technical committee and must 3d802 reviewed every? A superscript epsilon e indicates an editorial change since the last revision or reapproval.

Summary of Test Method 4. Conceding the fact that the test does not actually measure in-service resistance to degradation, it can be used to establish the comparability of lots ostensibly of the same grade of carbon. Table 1 lists the hardness test sieve corresponding to each minimum nominal sieve.

ASTM D3802 – 16

BoxGastonia, NChas been found to be satisfactory. The adhesion of material to sieves, brushes, etc. Apparatus and Materials 6.