Airport Information For EHRD. Printed on 27 Jan . Chart only to be used for cross-checking of altitudes while under. RADAR control. 2. VFR Chart of EHRD. IFR Chart of EHRD. Location Information for EHRD. Coordinates: N51°’ / E4°’ View all Airports in Zuid-Holland, Netherlands. Remain on Tower frequency until passing ‘, then contact SCHIPHOL. Departure and report altitude in order to verify SSR mode C by ATC.

Author: Nile Akinodal
Country: Romania
Language: English (Spanish)
Genre: Finance
Published (Last): 6 October 2015
Pages: 247
PDF File Size: 4.45 Mb
ePub File Size: 15.34 Mb
ISBN: 680-8-24565-887-6
Downloads: 40041
Price: Free* [*Free Regsitration Required]
Uploader: Kigagrel

Make a full stop landing and vacate as soon as possible. Departure instructions will be given. Standard instrument departure SID. GP 06 – Four low visibility phases are recognised:. After arrival over the holding fix intercept the holding pattern.

IFR Terminal Charts for Rotterdam-Zestienhoven (EHRD) (Jeppesen EHRD)

Noise abatement has been included in the procedures. Runway in use 1.

The airport is below operational limits for arriving and departing aircraft. Righthand circuit, altitude ft AMSL. Pilots shall request permission from ATC before starting engines and when applicable report a cross-bleed start. GP 24 – For obstacles in take-off area see AD 2.

During periods of low visibility the overall ATC capacity is reduced. Join the circuit as instructed by ATC.

EHRD – Rotterdam Airport | SkyVector

When radar control is exercised the aircraft will be directed to a position, from which a final instrument approach or a visual approach can be made. Follow-me service is mandatory during taxiing. Marked areas shall be avoided. Initiate turns in due time in order not to overshoot radials.


Pilots must have obtained start-up clearance from ATC before starting engines. Limited use of intersection take-offs. An en route clearance contains:. H24 for emergency, rescue, police, coastguard, military and ambulance flights.

Wrong ILS APP Draw – Archive – Flight Sim Labs Forums

Maintain the last cleared and acknowledged flight level or altitude. Adhere strictly to the follow-me instructions. When using friction tester: The execution of training flights is prohibited daily from International Medical Care B. Since separation is based on the calculated areas, compliance with these in-flight procedures is essential.

TWR Rotterdam Tower Measured coefficient Estimated surface friction 0. Permission for start-up will be issued either immediately or ehrs a specified time. Minimum climb gradient 8. Pilots shall strictly adhere to the circuits chatrs indicated on the charts, unless otherwise instructed by ATC. H24 for diverting aircraft due to meteorological or technical reasons AD may be filed as alternate.

Since ATC planning of outbound traffic involving en route clearance and co-ordination with adjacent ACCs is based on the start-up time, the pilot shall be able to comply with start-up and taxi permission. The instrument departure procedures are laid down in standard instrument departures SIDs. Taxiing only allowed under the guidance of a marshaller or with a follow-me car.


Box GC Ridderkerk. These areas are indicated on the chart. Measuring of estimated surface friction: For each runway at Rotterdam Airport chagts circling approach may be allowed or offered.

Start climbing and chartd the turn to the intended landing runway see figure. The Flight Service Centre charte be reached by telephone H These instructions may comprise an opposite turn after take-off, maintaining a specified heading or temporary altitude restrictions; this additional instructions amend the relevant part of the SID only.

In case of communication failure over or after a position from where to join the circuit this is past the reporting point PAPA execute a circuit for the last received and acknowledged runway as short as practicable. Chzrts it is safe to do so, the DMO will declare that ground handling and re-fuelling operations can be resumed. All TWYs except V4: Turn anticipation is mandatory for all waypoints except those which are underlined, these waypoints shall be overflown.

An en route clearance contains: In case of an overshoot enter the relevant traffic circuit and inform ATC.

The request for start-up shall cyarts made to Rotterdam Delivery after all preparations for departure have been made doors closed etc. Departure instructions if applicable.